Atlas® Aluminum Marker Ledge with Angled Corners

Atlas® aluminum marker ledges with a contemporary angle cut ends or corners. The smooth angle cut corner removes any sharp corners from the tray and makes it look awesome.

Atlas® aluminum marker trays are made in the U.S.A. to order but still typically ship in as little as 2-5 working days. Available as small as 18" long up to 12' as a single unit.

You can order up to 16' in a two-piece unit. One end will be square and the other end of the two pieces has the angle cut. Match up the two square corners and it gives the impression of a single continuous length of marker tray.

Atlas® aluminum marker trays are all made in the U.S.A. Note: Cut tolerances on all marker trays is +/- ¼"

Features:
• Heavy Gauge Aluminum
• Blade style marker tray with Smooth Angle Cut Ends
• Back Panel is 2 1/8" High
• Blade is 1/8" thick and 2 ¼" deep
• 7/8" of the Back Panel is above the blade
• 1 1/8" of the Back Panel is below the blade
• Lower back panel can be drilled through for permanent installation with wall anchors and wall screws.
• Installation hardware is Not Included
• Units up to 8' in length ship by UPS
• Longer 2-Piece units available that ship by UPS.
• Single section 10' and 12' units available. They ship by truck.
• Cut tolerance of +/- ¼"
• Custom lengths available through customer service. 18" is the shortest length available.
• Lead-time is 2-5 business days shipping from Shrewsbury, MA
• Made in the U.S.A.