OptiMA® Atlas® Aluminum Marker Tray Ledge

Atlas® aluminum marker tray ledges and or blade style chalk trays are 2 1/8" high x 2 1/4" deep. 7/8" of the backing shows above the blade tray and 1 1/8" shows below the tray. The marker tray has a flat aluminum back panel that can be drilled through for fast and permanent installation and an extra deep ledge for markers and accessories. Installation hardware is NOT included with these chalk trays.

Special Volume Discounts:
• Order 6 Units of the Same Size and get an automatic 10% Discount on those units
• Order 12 Units of the Same Size and get an automatic 15% Discount on those units
• Order 24 or more Units of the Same Size and get an automatic 20% Discount on those units
• Units must be the same size and shipping to the same location to get the discount
• Contact customer service if you need assistance

On 2-piece units, we angle one end of each section and the other end will have a square corner so that you can butt the two pieces side by side to create the illusion of a longer tray. Again, the advantage of this is that the 2-piece trays can still ship by UPS.

We offer single, one piece marker trays with square corners in 1' increments from 1' up to 12' long. We also offer 2-piece trays in lengths of 10' to 16' long so that they can still ship by UPS. All lengths up to 8' long can still ship by UPS. Any length over 8' long has to go by truck because of the size restrictions in UPS.

In addition to the square corner marker trays, we also offer really nice contemporary smooth angle cut ends. These angle cut trays are available in one piece units in 1' increments from 18" up to 12' long and in 2-piece units in lengths 10', 12', 14' and 16'.